IMEL7000/ECEN7003_001
Fall 2024
General Project Report Outline Reference
You have to hand in project reports for the projects in this course. The project report should be comprehensive, clear and brief. Captured schematics and simulated waveforms should be legible and with proper explanations. For group projects, only one report is required per group, but the individual contribution should be clearly justified. You should use the following general outline as a reference for your reports. You may include the appendix and references if necessary.
1. Personal Information: Include the course code and name, project number and title, your full name and student ID.
2. Summary: A table summarizing the design parameters, and comparing calculated and simulated results.
3. Introduction: Overview of the project and the objective of your approach and justification
4. Suggested contents (but not limit to)
(1). DC Hand Calculations:
a) DC calculations
b) Simulation results (plots/waveforms)
c) Comparison between calculated and simulated results
d) Problems encountered and solutions
(2). AC Hand Calculations:
a) Small-signal calculations
b) Simulation results (plots/waveforms)
c) Comparison between calculated and simulated results
d) Problems encountered and solutions
(3). Conclusions:
a) A summary of your design
b) Discussion on the results obtained
c) Discussion on the problems, solutions and possible improvements
5. Appendix/References: (only if necessary)
Remark:
• The maximum number of pages for the report is 5 in IEEE double-column format with reasonable figure size.
• The format of the report should be pdf.
• Important: the filename of your report should be PX_YYYYYYY, where X is the project number, YYYYYYY is your student ID, i.e. if your student number is DC12345 and you are handing in your project 1 report which is a pdf file, your filename should be “P1_MC12345.pdf”.
• Post-layout simulation results with comparison and discussion will be considered as a bonus.